This module describes the skills and knowledge required to set a TV and Radio studio technically by setting the audio and Video parameters to ensure that a system is well connected based on generated source message and broadcasted to the community effectively
At the end of this module a trainee will be able to:
· Install a radio and TV studio,
· Mixes audio and video signals based on signal quality requirements,
· Set up an adequate lighting in a studio and
· Manipulate audio and video mixers
Contents
Learning unit 1: Prepare for audio and video mixer for operation
1.1 Describe audio and video Mixer
1.2 Connect cables and accessories
1.3 Start and interpret audio and video mixer alarms
Learning unit 2: Set up sound system
2.1 Set up microphones
2.2 Set up mixers
2.3 Set up speakers
2.4 Interconnect sound equipment
2.5 Test the sound system
Learning unit 3: Manipulate the audio and video mixers
3.1 Adjust an audio signal parameter
3.2 Adjust video signal parameter
3.3 Mix signals to be broadcasted
Learning unit 4: Operate radio assist softwares
4.1Differentiate radio assist software
4.2 Play and record broadcast programs
4.3 Edit audio recording electronically
4.4 Communicate to other operators
Learning unit 5: Install studio lighting system
5.1 Prepare equipment, tools and consumables
5.2 Interconnect lighting system equipment
5.3 Test the lighting system
Learning unit 6: Hand over and document the work done
6.1 Report about equipment status
6.2 Document about any challenges
6.3 Hand over to next shift operator
- Teacher: AKAYEZU Delphine