This module describes the knowledge, skills and attitude required to perform vehicle trim repairing.
This module is intended to students pursuing diploma in automobile technology. At the end of this module, the students will be able to identify, describe, check, remove, repair, replace, fit and clean vehicle trim components and verify vehicle trim components.
This module describes the knowledge, skills and attitude required to perform vehicle trim repairing.
This module is intended to students pursuing diploma in automobile technology. At the end of this module, the students will be able to identify, describe, check, remove, repair, replace, fit and clean vehicle trim components and verify vehicle trim components.
This course consists of the following units:
Unit 1: Introduction
Unit 2: Design of shafts
Unit 3: Riveted joints
Unit 4: Welded joints
Unit 5: springs
Panel beating and Painting refers to the reshaping and Resizing of vehicle damaged body to the original shape and size respectively.
This course will enable student to acquire competencies of conducting research, preparation and presentation of final report.
This course is composed by 4 sessions. The first session is revision of covered sessions and reminders about the given assignment, the 3 remaining sessions comprise the new content.
After each session there is an activity which is mandatory to be done and submitted.